Other SBS Sports · 5d ago

The Surprising Culprit Behind the U.S. Nationwide Flight Grounding: 'It Wasn't Broken'

Key Points
  • Two newly installed Juniper routers at FAA facilities in Arkansas and Texas sent 1,000 connection signals every 4–5 seconds, overloading 17 of 22 U.S. air route traffic control centers and forcing a n
  • Manufacturer Hewlett Packard Enterprise stated the routers were not broken and appeared to be operating as intended, prompting officials to investigate whether a contractor configuration error or hard
  • The FAA has been upgrading its aging copper-line air traffic control network to fiber-optic systems, and the incident was resolved only after the two routers were disconnected and a specific feature w
Summary A massive nationwide flight grounding across the United States on November 13—dubbed an "airport chaos" event (*gonghang daeran*) in Korean media—was caused by newly installed network routers overwhelming the Federal Aviation Administration's (FAA) air traffic control communication system, according to a *Wall Street Journal* report cited by SBS News. Citing government and industry officials, the report revealed that the disruption began shortly after defense contractor L3Harris Technologies installed new router equipment at an FAA communication facility in El Dorado, Arkansas, on November 13. A router is a core networking device that directs where data travels across a computer network to keep communication flowing smoothly. Soon after installation, the Arkansas router—along with another router at a radar facility in Amarillo, Texas—began flooding the FAA's nationwide communication network with massive amounts of data. According to officials, the two routers sent 1,000 connection signals every four to five seconds across the entire network. This sudden surge overloaded other equipment and knocked out communications at 17 of the 22 air route traffic control centers across the United States, directly triggering the FAA's nationwide ground stop order that afternoon. Air traffic control communications only stabilized after the FAA disconnected the Arkansas and Texas routers from the network. Reuters also reported, citing the FAA safety employees' union and other sources, that the issue was isolated to two routers updated on November 13 in Arkansas and Texas. The FAA has been in the middle of modernizing its aging, copper-wire-based air traffic control communication system with advanced fiber-optic equipment. The routers at the center of the incident were made by Juniper Networks, a company known for high-speed data center networking gear that was acquired by Hewlett Packard Enterprise (HPE) last year. Roughly 60 Juniper routers are currently operating normally within the FAA's air traffic control network. Intriguingly, an HPE spokesperson told the *Wall Street Journal* that the Juniper equipment in question appeared to be operating as intended and was "not broken." FAA officials have since identified a specific feature on the routers believed to have caused the data overload and have disabled it across all Juniper routers in the agency's control system. While the system has been restored, authorities are still investigating whether the incident stemmed from a hardware defect or a configuration mistake by the contractor. Speaking at a press conference, U.S. Transportation Secretary Sean Duffy stated that officials are working to determine whether the root cause was contractor incompetence or a faulty router, noting that the exact cause of the failure has not yet been finalized.
Sponsored · Ad